Dual Channel 12S Lipo Lithium Battery Charger 3 Working Modes, Fast
Charger, Balance Charger and Storage
Introduction:
PC1260 is a dual channel LiPo battery charger, which is capable of
balance charging 2 packs of 12 cell LiPo batteries simultaneously.
There are three working modes, fast charge, balance charge and
storage.
PC1260 is easy to operate, and its Master-Slave mode can help avoid
unnecessary settings. With this mode available, pieces of PC1260
charger units are able to be connected and controlled for
synchronous settings through data cables, thus significantly saving
time for setting. In addition, PC1260 has short-circuit, reverse
polarity and over-heat protection to ensure maximum safety.
Feathres
| Support charging 2 packs of 12s LiPo batteries simultaneously | Support LiPo high voltage (LiHV) battery |
| Memorizing last charging current | Three working modes: fast charge, balance charge & storage |
| Mater-Slave mode available | Synchronize 2 or more chargers via data cable |
| Maximum safety: short circuit protection, reverse polarity
protection & over heat protection | Adjustable charge current (1.0-12.0A) |
| 2x16 LCD screen | Battery voltage meter |
| Battery internal resistance meter | Firmware upgrade via USB port |
Specifications
Input Voltage: 100-240V
Output Power: 1260W (630W*2)
Discharge Power: 100W (50W*2)
Charge Current: 1.0-12.0A*2
Balance Current: 1.5A
Battery Type: LiPo/LiHV
Battery Cell: 12S*2
Working Mode: Fast charge / Balance charge / Storage
Size: 272*202*118.6mm
Weight: 4.88kg
Warning and safety precautions
These warnings and safety notes are particularly important. Please
follow the instructions for maximum safety.
Otherwise the charger and the battery can be damaged or at worst it
can catch fire.
Never leave the charger unattended when it is connected to its
power supply. If any malfunction is found, TERMINATE THE PROCESS AT
ONCE and refer to the operation manual.
Keep the charger well away from dust, moist, rain, heat, direct
sunshine and vibration.
Never drop it.
The allowable AC input voltage is AC 100-240V.
This charger and the battery should be put on a heat-resistant,
non-inflammable and non-conductive surface.
Never place them on a car seat, carpet or the like. Keep all the
inflammable and volatile materials away from
the operating area.
Make sure you know the specifications of the battery to be charged
or discharged to ensure it meets the requirements of this charger.
If the program is set up incorrectly, the battery and charger may
be damaged. It can cause fire or explosion due to overcharging.
Never attempt to charge or discharge the following types of
batteries
A battery pack which consists of different types of cells
(including different manufacturers)
A battery already fully charged or just slightly discharged
Non-rechargeable batteries (Explosion hazard)
A battery requires a different charge technique
A faulty or damaged battery
A battery fitted with an integral charge circuit or a protection
circuit.
Batteries installed in other devices or connected to other parts.
Batteries that are not expressly stated by the manufacturer to be
suitable for the currents the charger delivers during the charge
process.
